Inspection Procedure

1. Remove the switch.
2. Measure the resistance of the switch when the switch is operated.

   Resistance 

   RESISTANCE SPECIFICATION
   
   

   Switch Condition	Tester Connection	Specified Condition
   AUTO UP	1 (D) - 7 (E) 6 (U) - 12 (BW)	Below 1Ω
   UP	1 (D) - 7 (E) 6 (U) - 12 (BW)	Below 1Ω
   OFF	1 (D) - 7 (E) 6 (U) - 7 (E)	Below 1Ω
   DOWN	6 (U) - 7 (E) 1 (D) - 12 (BW)	Below 1Ω
   AUTO DOWN	6 (U) - 7 (E) 1 (D) - 12 (BW)	Below 1Ω

NG: REPLACE MULTIPLEX NETWORK SWITCH ASSEMBLY 

Fig 1: Identifying G6 Multiplex Network Switch Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: PROCEED TO NEXT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE