Front Axle Hub: Installation

INSTALL FRONT AXLE ASSEMBLY LH
1. Align the matchmarks and install the front drive shaft assembly LH to the front axle hub sub-assembly LH.
  
  Fig 1: Installing Front Drive Shaft LH To Front Axle Hub Sub-Assembly LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the steering knuckle LH with the front axle hub sub-assembly LH to the shock absorber assembly front LH with the 2 bolts and 2 nuts.
  Torque: 210 N*m (2.140 kgf*cm, 155 ft.*lbf)
  NOTE:
  - Only when reusing the bolts and nuts, apply a small amount of engine oil to the threads of the nuts.
  - Be careful not to damage the drive shaft boot and speed sensor rotor.
  Fig 2: Installing Front Axle Hub Sub-Assembly LH To Shock Absorber Assembly LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO.1 LH (See INSTALLATION )
INSTALL TIE ROD END SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT DISC
INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH
1. Install the front disc brake caliper assembly LH to the steering knuckle LH with the 2 bolts.
  Torque: 107 N*m (1.090 kgf*cm, 79 ft.*lbf)
  
  NOTE: Do not twist the brake hose when installing the front disc brake caliper assembly LH.
  
  Fig 3: Locating Steering Knuckle LH With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT AXLE HUB LH NUT
1. Using a socket wrench (30 mm), install a new axle hub LH nut.
  Torque: 294 N*m (3.000 kgf*cm, 217 ft.*lbf)
  
  HINT:
  
  Stake the nut after inspecting for looseness and runout through the following steps.
SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY LH
1. Remove the 2 bolts and separate the front disc brake caliper assembly LH from the steering knuckle LH.
  NOTE: Use a wire or an equivalent to keep the brake caliper from hanging down by the flexible hose.
REMOVE FRONT DISC
INSPECT FRONT AXLE HUB BEARING LOOSENESS (See ON-VEHICLE INSPECTION )
INSPECT FRONT AXLE HUB RUNOUT (See ON-VEHICLE INSPECTION )
INSTALL FRONT DISC
INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH
1. Install the front disc brake caliper assembly LH with the 2 bolts to the steering knuckle LH.
  Torque: 107 N*m (1.090 kgf*cm, 79 ft.*lbf)
  
  NOTE: Do not twist the brake hose when installing the front disc brake caliper assembly LH.
INSTALL SPEED SENSOR FRONT LH (See INSTALLATION )
INSTALL FRONT AXLE HUB LH NUT
1. Using a chisel and hammer, stake the axle hub LH nut.
Fig 4: Staking Axle Hub LH Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT WHEEL
Torque: 103 N*m (1.050 kgf*cm, 76 ft.*lbf)
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
1. Inspect and adjust front wheel alignment (See FRONT WHEEL ALIGNMENT ).
CHECK ABS SPEED SENSOR SIGNAL
1. ABS WITH EBD & TRAC & VSC SYSTEM (See TEST MODE PROCEDURE )
2. ABS WITH EBD SYSTEM (See TEST MODE PROCEDURE )