Crankshaft Position Sensor: Installation
- INSTALL CRANKSHAFT POSITION SENSOR
- Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
- Install the crankshaft position sensor with the bolt.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
- Connect the crankshaft position sensor connector.
- INSTALL COOLER COMPRESSOR ASSEMBLY (See INSTALLATION )
- INSTALL GENERATOR ASSEMBLY (See INSTALLATION )
- INSTALL FAN AND GENERATOR V BELT (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- PERFORM SYSTEM INITIALIZE
Some systems need initialization when disconnecting the cable from the negative battery terminal.