Torque Specifications
WARNING: This page is about a different car, the 2005 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Part Tightened | N.m | kgf.cm | ft.lbf |
|---|---|---|---|
| Front floor heat insulator No.1 at Body | 5.5 | 56 | 49 in.lbf |
| Airbag sensor assy center at Body | 18 | 180 | 13 |
| Shift cable grommet retainer No.1 at Body | 5.0 | 51 | 44 in.lbf |
| Clamp at Body | 5.0 | 51 | 44 in.lbf |
| Floor shift, shift lever assy at Body | 12 | 122 | 9 |
| Filler and drain plugs | 39 | 400 | 29 |
| Engine hanger set bolt | 38 | 387 | 28 |
| Engine mounting bracket RR at Transaxle | 64 | 653 | 47 |
| Engine mounting bracket RR at Engine mounting insulator RR | 65 | 663 | 48 |
| Engine mounting bracket FR at Transaxle | 64 | 653 | 47 |
| Engine mounting bracket FR at Engine mounting insulator FR | 52 | 530 | 38 |
| Manual transaxle assy at Engine Bolt A: | 64 | 650 | 47 |
| Manual transaxle assy at Engine Bolt, Bolt B: | 47 | 480 | 35 |
| Manual transaxle assy at Engine Bolt, Bolt C: | 23 | 230 | 17 |
| Engine mounting bracket LH at Transaxle | 52 | 530 | 38 |
| Engine mounting insulator LH set bolt, Bolt A: | 52 | 530 | 38 |
| Engine mounting insulator LH set bolt Nut B: | 80 | 816 | 59 |
| Starter assy at Manual transaxle assy | 37 | 378 | 27 |
| Starter wire set nut | 13 | 131 | 9 |
| Clutch release cylinder assy at Transaxle Bolt A: | 25 | 250 | 19 |
| Clutch release cylinder assy at Transaxle Bolt B: | 12 | 120 | 9 |
| Clutch release cylinder assy at Transaxle Bolt C: | 5.0 | 51 | 44 in.lbf |
| Manual transaxle assy at Wire harness clamp Bolt A: | 26 | 260 | 19 |
| Manual transaxle assy at Wire harness clamp Bolt B: | 13 | 131 | 9 |
| Manual transaxle assy at Ground cable | 13 | 133 | 10 |
| Battery carrier at Body | 13 | 133 | 10 |
| Battery clamp sub-assy at Body Bolt: | 5.0 | 51 | 44 in.lbf |
| Battery clamp sub-assy at Body Nut: | 3.5 | 36 | 31 in.lbf |
| Air cleaner assy at Body | 7.0 | 71 | 62 in.lbf |
| Cylinder head cover No.2 at Engine | 7.0 | 71 | 62 in.lbf |
| Hood set bolt | 13 | 133 | 10 |
| Front differential case at Front differential ring gear | 77 | 789 | 57 |
| Selecting bell crank at Selecting bell crank No.2 | 12 | 120 | 9 |
| MANUAL TRANSAXLE ASSY (C59) | |||
| Bearing lock plate at transaxle case | 11 | 115 | 8 |
| Oil receiver pipe No.1 at Manual transmission case | 17 | 175 | 13 |
| Oil receiver pipe No.2 at Manual transmission case | 17 | 175 | 13 |
| Reverse restrict pin plug at Manual transmission case | 13 | 130 | 9 |
| Manual transaxle case receiver at Transaxle case | 11 | 115 | 8 |
| Gear shift fork No. 1 at Gear shift fork shaft No.1 | 16 | 160 | 12 |
| Gear shift head No.1 at Gear shift fork shaft No.2 | 16 | 160 | 12 |
| Gear shift fork No.2 at Gear shift fork shaft No.2 | 16 | 160 | 12 |
| Reverse shift arm bracket assy at Transaxle case | 17 | 175 | 13 |
| Transaxle case at Manual transmission case | 29 | 300 | 22 |
| Manual transmission case at Transaxle case | 29 | 300 | 22 |
| Reverse idler gear shaft bolt at Manual transmission case | 29 | 300 | 22 |
| Lock ball assy No.1 at Manual transaxle assy | 29 | 296 | 21 |
| Shift detent ball plug Manual transmission case | 22 | 224 | 16 |
| Shift detent ball plug at Transaxle case | 22 | 224 | 16 |
| Bearing retainer rear at Manual transmission case | 27 | 279 | 20 |
| Gear shift fork No.3 at Gear shift fork shaft No.3 | 16 | 160 | 12 |
| Manual transmission output shaft rear set nut at Output shaft | 118 | 1,200 | 87 |
| Manual transmission case cover sub-assy at Manual transmission case | 18 | 185 | 13 |
| Shift & select lever shaft assy at Manual transmission case | 20 | 200 | 14 |
| Lock ball assy No. 1 at Manual transmission case | 29 | 300 | 22 |
| Selecting bell crank assy at Manual transmission case | 25 | 250 | 18 |
| Floor shift control lever housing support bracket at Transaxle case | 18 | 184 | 13 |
| Back up lamp switch assy at Manual transmission case | 40 | 411 | 30 |
| Speedometer driver hole cover sub-assy at Manual transaxle assy | 11 | 115 | 8 |
| Speedometer sensor at Manual transaxle assy | 11 | 115 | 8 |
| Release fork support at Transaxle case | 37 | 375 | 27 |
| Drain plug sub-assy at Manual transmission case | 39 | 400 | 29 |
| Manual transmission filler plug at Manual transmission case | 39 | 400 | 29 |
| MANUAL TRANSAXLE ASSY (C60) | |||
| Bearing lock plate at transaxle case | 11 | 115 | 8 |
| Manual transaxle case receiver at Transaxle case | 11 | 115 | 8 |
| Reverse shift arm bracket assy at Transaxle case | 17 | 175 | 13 |
| Gear shift head No.1 at Gear shift fork shaft No.2 | 16 | 160 | 12 |
| Gear shift fork No.2 at Gear shift fork shaft No.2 | 16 | 160 | 12 |
| Gear shift fork No.1 at Gear shift fork shaft No.1 | 16 | 160 | 12 |
| Oil receiver pipe No.2 at Manual transmission case | 17 | 175 | 13 |
| Oil receiver pipe No.1 at Manual transmission case | 17 | 175 | 13 |
| Transaxle case at Manual transmission case | 29 | 300 | 22 |
| Manual transmission case at Transaxle case | 29 | 300 | 22 |
| Reverse idler gear shaft bolt at Manual transmission case | 29 | 300 | 22 |
| Manual transmission case plug at Manual transaxle assy | 39 | 400 | 29 |
| Shift detent ball plug at Manual transmission case | 22 | 224 | 16 |
| Reverse restrict pin at Manual transmission case | 29 | 296 | 21 |
| Back up lamp switch assy at Manual transmission case | 40 | 411 | 30 |
| Shift & select lever shaft assy at Manual transmission case | 20 | 200 | 14 |
| Lock ball assy No.1 at Manual transmission case | 29 | 300 | 22 |
| Bearing retainer rear at Manual transmission case | 27 | 279 | 20 |
| Gear shift fork No.3 at Gear shift fork shaft No.3 | 16 | 160 | 12 |
| Manual transmission case cover sub-assy at Manual transmission case | 18 | 185 | 13 |
| Drain plug sub-assy at Manual transmission case | 39 | 400 | 29 |
| Manual transmission filler plug at Manual transmission case | 39 | 400 | 29 |
| Selecting bell crank assy at Manual transmission case | 25 | 250 | 18 |
| Floor shift control lever housing support bracket at Transaxle case | 18 | 184 | 13 |
| Speedometer driver hole cover sub-assy at Manual transaxle assy | 11 | 115 | 8 |
| Release fork support at Transaxle case | 37 | 375 | 27 |