Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

CHECK MAP DISC
1. Check that the map disc is not deformed or cracked.
  OK: No deformations or cracks on map disc.
NG: REPLACE MAP DISC

Fig 1: Identifying Wrong Method Of Disc Cleaning
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: Go to Next Step
CHECK MAP DISPLAY
1. Check if a touch scroll can be performed on the map display.
  OK: Touch scroll can be performed.
NG: PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE

OK: Go to Next Step
CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)
1. Enter the "Navigation Check" mode (Vehicle Sensors) (see NAVIGATION CHECK MODE ).
2. While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check if these readings are almost equal.
  OK: The readings are almost equal.
NG: GO TO SPEED SIGNAL DOES NOT CHANGE IN NAVIGATION CHECK MODE IN PROBLEM SYMPTOMS TABLE

Fig 2: Diagnostic Tool Display - Navigation Check Mode
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE