Front Axle Hub: Disassembly

REMOVE FRONT AXLE HUB OIL SEAL AND BEARING
1. Using a screwdriver, pry out the oil seal.
2. Remove the bearing from the axle hub.
REMOVE AXLE HUB BEARING OUTER RACE
1. Using a brass bar and hammer, tap out the outside bearing outer race.
  NOTE: Be careful not to damage the ABS speed sensor rotor.
  
  Fig 1: Tapping Out Outside Bearing Outer Race
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a brass bar and hammer, tap out the inside bearing outer race.
INSPECT AXLE HUB BEARINGS
1. Clean the bearings and outer races and inspect them for wear or damage.
  
  Fig 2: Tapping Out Inside Bearing Outer Race
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT DISC
1. Mount the axle hub with the disc in a soft jaw vise.
  NOTE: Close the vise until it holds the disc, and do not tighten it further.
2. Place matchmarks on the axle hub and disc.
3. Remove the 5 bolts and separate the axle hub and disc.
  
  Fig 3: Placing Matchmarks On Axle Hub & Disc
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002