LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2007 >> Land Cruiser >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Axle) >> Front Axle Hub >> Reassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Axle Hub: Reassembly

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FRONT DISC 
    1. Mount the disc in a soft jaw vise.
      NOTE: Close the vise until it holds the disc, and do not tighten it further.
    2. Align the matchmarks on the axle hub and disc.
    3. Install the 5 bolts to the axle hub.

      Torque: 74 N*m (750 kgf*cm, 54 ft.*lbf) 

      Fig 1: Aligning Matchmarks On Axle Hub & Disc
      G04437341Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL AXLE HUB BEARING OUTER RACE 
    1. Using SST and a hammer, carefully install a new outside bearing outer race.

      SST 09950-60020 (09951-00730), 09950-70010 (09951-07100) 

      Fig 2: Installing Axle Hub Bearing Outer Race Using SST & Hammer
      G04437342Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using SST and a hammer, carefully install a new inside bearing outer race.

      SST 09950-60020 (09951-00890), 09950-70010 (09951-07100) 

      NOTE: Be careful not to damage the ABS speed sensor rotor.
      Fig 3: Installing Inside Bearing Outer Race Using SST & Hammer
      G04437343Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. PACK AXLE HUB BEARING WITH MP GREASE 
    1. Place MP grease in the palm of your hand.
    2. Pack grease into a new bearing, continuing until the grease oozes out from the other side.
    3. Employ the same manner around the bearing circumference.
      Fig 4: Placing MP Grease In Palm Of Hand
      G04437344Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. COAT INSIDE OF AXLE HUB WITH MP GREASE 
  5. INSTALL FRONT AXLE HUB INNER BEARING 
    1. Place the inner bearing into the axle hub.
      Fig 5: Coating Inside Of Axle Hub With MP Grease
      G04437345Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL FRONT AXLE HUB OIL SEAL 
    1. Using SST and a hammer, tap in a new oil seal into the axle hub.

      SST 09950-60020 (09951-01030), 09950-70010 (09951-07100) 

      NOTE: Be careful not to damage the ABS speed sensor rotor.
    2. Coat the lip of the oil seal with MP grease.
      Fig 6: Installing Front Axle Hub New Oil Seal
      G04437346Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals