Air Conditioning Control Assembly: Removal

REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (See REMOVAL )
REMOVE COMBINATION SWITCH ASSEMBLY
REMOVE AIR CONDITIONING CONTROL ASSEMBLY
1. Using a screwdriver, open the claw of the cable clamp and disconnect the defroster damper control cable.
  NOTE:
  - Be careful not to bend the cable wire.
  - If the cable wire bends, the air conditioning control assembly operationality becomes worse.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 1: Disconnecting Defroster Damper Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Release the 2 fitting claws and pull out the air conditioning control assembly, as shown in the illustration.
  
  Fig 2: Removing Air Conditioning Control Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a screwdriver, open the claw of the cable clamp and disconnect the airmix damper control cable.
  NOTE:
  - Be careful not to bend the cable wire.
  - If the cable wire bends, the air conditioning control assembly operationality becomes worse.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 3: Disconnecting Airmix Damper Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disconnect the connector and remove the air conditioning control assembly.