DTC P0504 Brake Switch "A" / "B" Correlation: Description
The stop light switch is a duplex system that transmits two signals: STP and ST1-. These two signals are used by the ECM to monitor whether or not the brake system is working properly. If the signals, which indicate the brake pedal is being depressed and released, are detected simultaneously, the ECM interprets this as a malfunction in the stop light switch and sets the DTC.
HINT:
The normal conditions are as shown in the table below. The signals can be read using an intelligent tester.
BRAKE PEDAL POSITIONS
| Signals | Brake Pedal Released | In Transition | Brake Pedal Depressed |
|---|---|---|---|
| STP | OFF | ON | ON |
| ST1- | ON | ON | OFF |
DTC DETECTION CONDITIONS AND TROUBLE AREAS REFERENCE
| DTC No. | DTC Detection Conditions | Trouble Areas |
|---|---|---|
| P0504 | Conditions (a), (b) and (c) continue for 0.5 seconds or more (1 trip detection logic):
|
|