Oil Pump: Reassembly

INSTALL FRONT OIL PUMP DRIVEN GEAR
1. Make sure the top of the front oil pump driven gear are facing upward.
Fig 1: Identifying Front Oil Pump Driven Gear
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVE GEAR
1. Make sure the top of the front oil pump drive gear are facing upward.
INSTALL FRONT OIL PUMP OIL SEAL
1. Using SST and a hammer, install a new front oil pump oil seal. The seal end should be flush with the outer edge of the pump body.
  SST 09350-32014 (09351-32140)
  
  Fig 2: Installing Front Oil Pump Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STATOR SHAFT ASSEMBLY
1. Align the bolt holes of the stator shaft assembly with those of the pump body.
2. Torque the 11 bolts.
  Torque: 9.8 N*m (99 kgf*cm, 86 in.*lbf)
  
  Fig 3: Identifying Stator Shaft Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STATOR SHAFT CLUTCH DRUM THRUST WASHER
1. Coat the stator shaft clutch drum thrust washer with petroleum jelly.
2. Align the tab of the stator shaft clutch drum thrust washer with the hollow of the front oil pump body.
  
  Fig 4: Installing Stator Shaft Clutch Drum Thrust Washer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CLUTCH DRUM OIL SEAL RING
1. Install the 2 clutch drum oil seal rings to the stator shaft back side.
  NOTE: Do not spread the ring ends more than necessary.
  
  HINT:
  
  After installing the clutch drum oil seal rings, check that they move smoothly.
INSPECT OIL PUMP ASSEMBLY (See INSPECTION )