Inspection Procedure

HINT:

Read freeze frame data using an intelligent tester or OBD II scan tool. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air-fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2121) 
   1. Connect an intelligent tester or OBD II scan tool to the DLC3.
   2. Turn the ignition switch to ON.
   3. Turn the tester or scan tool ON.
   4. On the tester, select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
   5. Read DTCs.
   6. If using an OBD II scan tool, refer to the instruction manual.

      Result 

      DTC RESULT DESCRIPTION
      
      

      Display (DTC Output)	Proceed to
      P2121	A
      P2121 and other DTCs	B

      HINT:

      If any DTCs other than P2121 are output, troubleshoot those DTCs first.

   B: GO TO DTC CHART 

   A: Go to Next Step 

2. REPLACE ACCELERATOR PEDAL ASSEMBLY 
3. CHECK WHETHER DTC OUTPUT RECURS (DTC P2121) 
   1. Connect the intelligent tester or OBD II scan tool to the DLC3.
   2. Turn the ignition switch to ON.
   3. Turn the tester or scan tool ON.
   4. Clear DTCs (See DTC CHECK / CLEAR  ).
   5. Allow the engine to idle for a minute.
   6. Rev up the engine several times.
   7. On the tester, select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
   8. Read DTCs.
   9. If using an OBD II scan tool, refer to the instruction manual.

      Result 

      DTC RESULT DESCRIPTION
      
      

      Display (DTC Output)	Proceed to
      P2121	A
      No output	B

   B: CHECK FOR INTERMITTENT PROBLEMS 

   A: REPLACE ECM