Data List / Active Test
- DATA LIST
- While the intelligent tester is connected to the DLC3 with the ignition switch in the ON position, the CRUISE CONTROL data list can be displayed. Follow the prompts on the tester screen to access the data list.
CCS (ECM):
CCS (ECM) DATA LISTItem Measurement Item / Display (Range) Normal Condition Diagnostic Note VEHICLE SPD Vehicle speed / min.: 1 km/h (0.6 mph), max.: 255 km/h (158 mph) Actual vehicle speed - MEMORY SPD Cruise control memorized speed / min.: 1 km/h (0.6 mph), max.: 255 km/h (158 mph) Actual stored vehicle speed - THROTTLE Required throttle opening angle / min.: 0°, max.: 125° Actual required throttle opening angle - CRUISE CONTROL Cruise control system active condition / ON or OFF ON: Cruise control activated
OFF: Cruise control inactivated- MAIN SW (MAIN) Main SW signal (Main CPU) / ON or OFF ON: Main SW ON (Pushed on)
OFF: Main SW OFF (Pushed off)"3" MAIN SW (SUB) Main SW signal (Sub CPU) / ON or OFF ON: Main SW ON (Pushed on)
OFF: Main SW OFF (Pushed off)"3" CCS READY M Cruise control system standby condition (Main CPU) / ON or OFF ON ↔ OFF: ON/OFF changes each time Main SW is pushed in. "1" CCS READY S Cruise control system standby condition (Sub CPU) / ON or OFF ON ↔ OFF: ON/OFF changes each time Main SW is pushed in. "1" CCS INDICATOR Cruise indicator signal (Main CPU)/ON or OFF ON: "CCS READY" ON
OFF: "CCS READY" OFF"2" CCS INDICATOR S Cruise indicator signal (Sub CPU) / ON or OFF ON: "CCS READY" ON
OFF: "CCS READY" OFF"2" CANCEL SW CANCEL SW signal / ON or OFF ON: CANCEL SW ON
OFF: CANCEL SW OFF- SET/COAST SW SET/COAST SW signal / ON or OFF ON: SET/COAST SW ON
OFF: SET/COAST OFF- RES/ACC SW RES/ACC SW signal/ON or OFF ON: RES/ACC SW ON
OFF: RES/ACC SW OFF- STP LIGHT SW2 M Stop light SW signal (Main CPU) / ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released- STP LIGHT SW2 S Stop light SW signal (Sub CPU) / ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released- STP LIGHT SW1 S Stop light SW signal (Sub CPU) / ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released- SHIFT D POS PNP SW signal (D position) / ON or OFF ON: Shift position D
OFF: Any shift position except D- HINT: - "3" is OK but "1" is NG → ECM failure
- "1" is OK but "2" is NG → DTC output or ECM failure
- "3" is OK but the cruise indicator does not turn on → CRUISE MAIN indicator, wire harness or ECM failure
- While the intelligent tester is connected to the DLC3 with the ignition switch in the ON position, the CRUISE CONTROL data list can be displayed. Follow the prompts on the tester screen to access the data list.