Front Side Speaker: Removal

REMOVE FRONT DOOR PULL HANDLE LH (See DISASSEMBLY )
REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (w/ Power Window) (See DISASSEMBLY )
REMOVE UPPER FRONT ARMREST BASE PANEL LH (w/o Power Window) (See DISASSEMBLY )
REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) (See DISASSEMBLY )
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (See DISASSEMBLY )
REMOVE FRONT NO. 1 SPEAKER
1. Disconnect the connector.
2. Using a drill of less than ø 4 mm (0.16 in.), drill out the 3 rivet heads and remove the front No. 1 speaker from the front door panel.
3. Gently and vertically put the drill to the rivet, and cut the rivet flanges.
  NOTE:
  - Prizing the hole with a drill can lead to damage to the rivet hole or breaking the drill.
  - Take cafe as the cut rivet is hot.
    
    Fig 1: Drilling Out Rivet Heads
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Even if flange is taken off, continue drilling and push out remaining fragments with the drill.
5. Using a vacuum cleaner, remove the drilled rivet and their dust from the inside of the front door panel.
REMOVE FRONT NO. 2 SPEAKER
1. Disconnect the connector.
2. Remove the 2 nuts and front No. 2 speaker from the front door panel.
  
  Fig 2: Identifying Nuts And Front No. 2 Speaker
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002