Rear Axle Hub: Installation

INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH
1. Install the hub & bearing assembly LH with the 4 bolts.
  Torque: 61 N*m (622 kgf*cm, 45 ft.*lbf)
  
  Fig 1: Locating Hub & Bearing Assembly LH Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT SKID CONTROL SENSOR WIRE (WITH ABS)
NOTE: Do not twist the sensor wire when connecting it.
INSTALL REAR DISC (DISC REAR BRAKE TYPE)
INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH (DISC REAR BRAKE TYPE)
1. Install the rear disc brake caliper assembly LH with 2 bolts.
  Torque: 47 N*m (479 kgf*cm, 35 ft.*lbf)
  
  Fig 2: Locating Rear Disc Brake Caliper Assembly LH Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR BRAKE DRUM SUB-ASSEMBLY (DRUM REAR BRAKE TYPE)
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
INSPECT ABS SPEED SENSOR SIGNAL (WITH ABS)
1. Vehicle Stability Control System (See TEST MODE PROCEDURE )
2. Anti-lock Brake System (See TEST MODE PROCEDURE )