Transmission Control Cable: Installation

1. Install the retainer to the grommet.
   NOTE: Fit 4 projections of the grommet into 4 holes of the retainer.
   Fig 1: Identifying Retainer And Grommet

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the control cable assembly with the 2 bolts.

   Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

   Fig 2: Locating Control Cable Assembly With Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the shift cable with the 2 nuts.

   Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

   Fig 3: Locating Shift Cable With Nuts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the shift cable with the 2 clip from the bracket.
5. Connect the shift cable end of the shift cable with the 2 washer and 2 clip to the transaxle.
   Fig 4: Locating Shift Cable End Of Shift Cable

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the select cable to the shift lever assembly.
   NOTE:

   • The projecting part of the cable outer should face upward when the shift cable is installed.
   • Make sure that after installation the cable outer spring is moved to the place shown in the illustration.
     Fig 5: Connecting Select Cable To Shift Lever Assembly

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the select cable end with the clip to the shift lever assembly.
3. Connect the select cable to the clamp.
   Fig 6: Connecting Select Cable End With Clip To Shift Lever Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the shift cable to the shift lever assembly.
   NOTE:

   • The projecting part of the cable outer should face upward when the shift cable is installed.
   • Make sure that after installation the cable outer spring is moved to the place shown in the illustration.
     Fig 7: Connecting Shift Cable To Shift Lever Assembly

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the shift cable end as shown in the illustration.
   Fig 8: Identifying Shift Cable End

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the washer and clip.
4. Connect the shift cable to the clamp.

1. Install the heat insulator No. 1 with the 3 nuts.

   Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

HINT:

(See INSTALLATION )