Inspection Procedure

Fig 1: Checking Harness And Connector (Battery - Radio Receiver)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the radio receiver R16 connector.
2. Measure the resistance according to the values in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Condition	Specified Condition
   GND (R16-20) - Body ground (1)	Always	Below 1 Ω
   GND (R16-7) - Body ground (2)	Always	Below 1 Ω
   (1) Separate Type Amplifier (2) Built-in Type Amplifier

3. Measure the voltage according to the values in the table below.

   Standard voltage 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Condition	Specified Condition
   +B (R16-1) - GND (R16-20) (1)	Always	10 to 14 V
   B (R16-4) - GND (R16-7) (2)	Always	10 to 14 V
   ACC (R16-11) - GND (R16-20) (1)	Ignition SW ACC	10 to 14 V
   ACC (R16-3) - GND (R16-7) (2)	Ignition SW ACC	10 to 14 V
   (1) Separate Type Amplifier (2) Built-in Type Amplifier

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE