How To Proceed With Troubleshooting

HINT:

Use theses procedures to troubleshoot the rear view monitor system.

1. VEHICLE BROUGHT WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   If the voltage is below 11V, recharge or replace the battery before proceeding.

3. CHECK CAMERA LENS 
   1. Check that the camera lens is not dirty with mud, foreign matter, etc.
4. BASIC INSPECTION 
   1. Turn the power switch ON (ACC).
   2. Check whether or not the display appears on the multi-display.

      Result 

      RESULT
      
      

      Result	Proceed to
      Display appears	A
      Display does not appear	B

   B: Go to  NAVIGATION SYSTEM 

   A: Go to next step 

5. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B: Go to step  7

   A: Go to next step 

6. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. Terminals of ECU (see TERMINALS OF ECU  )
7. ADJUST, REPAIR OR REPLACE 

   NEXT: END