Crankshaft Position Sensor: Installation

INSTALL CRANKSHAFT POSITION SENSOR
NOTE: Make sure that the O-ring is not cracked or jammed when installing it.
1. Apply a light coat of engine oil to the O-ring of the sensor.
  
  Fig 1: Locating O-Ring On Crankshaft Position Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the sensor with the bolt.
  Torque: 9.0 N*m (90 kgf*cm, 80 in.*lbf)
3. Install the wire harness clamp.
4. Install the connector clamp.
5. Connect the sensor connector.
6. Confirm that the wire harness of the sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.
Fig 2: Connecting Sensor Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL GENERATOR ASSEMBLY
1. Install the generator to the vehicle (See INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
CHECK FOR ENGINE OIL LEAKAGE