Entry Interior Alarm does not Sound: Procedure
WARNING: This page is about a different car, the 2010 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK WHETHER ENGINE STARTS
- Check that the engine starts.
HINT:
The engine starts when the correct warning buzzer signal is transmitted from the steering lock ECU to the combination meter.
OK
Engine starts.
RESULTResult Proceed to OK A NG (2AR-FE) B NG (2GR-FE) C
C → See step 6
B → See step 4
A: Go to next step
- Check that the engine starts.
- CHECK COMBINATION METER ASSEMBLY (OPERATION)
- Place the door control transmitter in an undetectable area outside the vehicle, and turn the engine switch on (IG) with all doors closed.
OK
Warning buzzer sounds once.
NG → See step 5
OK → See step 3
- Place the door control transmitter in an undetectable area outside the vehicle, and turn the engine switch on (IG) with all doors closed.
- REPLACE ECU AGGREGATION BOX (CERTIFICATION ECU). Refer to REMOVAL
- Go to SMART KEY SYSTEM Refer to Engine does not Start
- Go to METER / GAUGE SYSTEM Refer to PROBLEM SYMPTOMS TABLE
- Go to SMART KEY SYSTEM Refer to Engine does not Start