LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2007 >> RAV4 Base, 2.4 D, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System (2GR-FE)) >> Crankshaft Position Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a coat of engine oil to an O-ring of the sensor.
    2. Install the sensor with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    3. Connect the sensor connector.
  2. INSTALL COMPRESSOR WITH PULLEY ASSEMBLY (Seepage AC-186) 
    Fig 1: Locating Crankshaft Position Sensor And Bolt
    G05184269Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL FAN AND GENERATOR V BELT  (see INSTALLATION )
  4. INSTALL RADIATOR ASSEMBLY 
    1. Install the radiator assembly (See INSTALLATION ).
  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  6. CHARGE REFRIGERANT  (see REPLACEMENT )
  7. ADD ENGINE COOLANT  (see REPLACEMENT )
  8. CHECK FOR LEAKAGE OF REFRIGERANT  (see REPLACEMENT )
  9. CHECK FOR ENGINE COOLANT LEAKS  (see ON-VEHICLE INSPECTION )
scientia non olet · About LEMON Manuals