Section 14 (Engine Control System (2GR-FE)): ECM: Removal

WARNING: This page is about a different variant/trim than selected.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE AIR CLEANER CAP (see REMOVAL )
REMOVE AIR CLEANER CASE (see REMOVAL )
REMOVE ECM
1. Remove the 3 bolts of the ECM bracket.
  
  Fig 1: Locating ECM Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the 2 ECM connectors.
  NOTE: After disconnecting the connector, make sure that dirt, water and other foreign matter does not contact the connecting part of the connector.
  1. Raise the 2 levers while pushing the locks on the 2 levers, and disconnect the 2 ECM connectors.
3. Remove the ECM with bracket.
  
  Fig 2: Locating ECM Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 4 screws and 2 ECM brackets.
Fig 3: Locating ECM Brackets And Screws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002