Confirmation Driving Pattern

WARNING: This page is about a different variant/trim than selected.

HINT:

Performing this confirmation pattern will activate the catalyst monitor. This is very useful for verifying the completion of a repair.

Fig 1: Confirmation Driving Pattern

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: Readiness Tests Screen Display - CAT CMPL Is INCMPL

Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the tester ON.
Clear DTCs (if set) (see DTC CHECK/CLEAR ).
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DATA LIST / USER DATA / CAT CMPL.
Check that CAT CMPL is INCMPL (incomplete).
Start the engine and warm it up.
Drive the vehicle at between 64 km/h and 113 km/h (40 mph and 70 mph) for at least 10 minutes.
Note the state of the Readiness Tests items. Those items will change to COMPL (complete) as CAT CMPL monitor operates.
On the tester, select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / PENDING CODES and check if any DTCs (any pending DTCs) are set.

HINT:

If CAT CMPL does not change to COMPL, and any pending DTCs fail to set, extend the driving time.