Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

READ CURRENT DTC

Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
Read DTCs.

Result

RESULT CHART

Display (DTC Output)	Proceed to
P0630	A
P0630 and other DTCs	B

If any DTCs other than P0630 are output, troubleshoot those DTCs first.

NOTE: If P0630 is set, the VIN must be input to the ECM using the intelligent tester. However, all DTCs are cleared automatically by the tester when the VIN is input. If DTCs other than P0630 are set, check them first.

B: GO TO DTC CHART

2: GO to Next Step

INPUT VIN WITH INTELLIGENT TESTER
1. Refer to the REGISTRATION .
NEXT: END