Inspection Procedure
WARNING: This page is about a different variant/trim than selected.
HINT:
- DTC P2610 is set if an internal ECM problem is detected. Diagnostic procedures are not required. ECM replacement is necessary.
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
- REPLACE ECM
- Replace the ECM (see INSPECTION PROCEDURE ).
- CHECK WHETHER DTC OUTPUT RECURS
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch ON.
- Turn the tester ON.
- Clear DTCs (see DTC CHECK/CLEAR ).
- Start the engine and wait for 10 minutes or more.
- On the tester, select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / PENDING CODES.
- If no pending DTC is displayed, the repair has been successfully completed.
NEXT: END