Data List / Active Test

1. Connect the intelligent tester to the DLC3.
2. Monitor the ECU data by following the prompts on the tester screen.

   HINT:

   The intelligent tester has a "Snapshot" function which records the monitored data.

   Refer to the intelligent tester operator's manual for further details.

HINT:

Using the DATA LIST displayed by the intelligent tester, you can read the values of the switch, sensor, actuator, etc. without parts removal. Reading the DATA LIST as the first step of troubleshooting is one way to shorten the labor time.

1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch ON.
3. Read the DATA LIST according to the display on the tester.

   Standard (Multiplex network body ECU): 

   DATA LIST - MULTIPLEX NETWORK BODY ECU
   
   

   Item	Measurement Item/ Display (Range)	Normal Condition	Diagnostic Note
   IG SW	Ignition switch signal/ ON or OFF	ON: Key is in ON or START position OFF: Key is in OFF or ACC position	-
   D DOR CTY SW	Driver side door courtesy switch signal/ ON or OFF	ON: Driver side door is open OFF: Driver side door is closed	-
   P DOR CYT SW	Passenger side door courtesy switch signal/ ON or OFF	ON: Passenger side door is open OFF: Passenger side door is closed	-

HINT:

Performing the ACTIVE TEST using the intelligent tester allows you to operate the relay, VSV, actuator, etc. without parts removal. Performing the ACTIVE TEST as the first step of troubleshooting is one way to shorten the labor time.

It is possible to display the DATA LIST during the ACTIVE TEST.

1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch ON.
3. Perform the ACTIVE TEST according to the display on the tester.

   Standard (Multiplex network body ECU): 

   MULTIPLEX NETWORK BODY ECU - ACTIVE TEST LIST
   
   

   Item	Test Detail	Diagnostic Note
   IG OFF P/W	Ignition switch OFF power window control permission output ON/OFF	-