Front Shock Absorber With Coil Spring: Installation

1. Install the front shock absorber with coil spring. Refer to Figure.
2. Install the 3 nuts to the upper side of the front shock absorber with coil spring.

   Torque: 80 N*m (816 kgf*cm, 59 ft.*lbf) 

   Fig 1: Installing Nuts To Upper Side Of Front Shock Absorber With Coil Spring

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the 2 bolts and 2 nuts to the lower side of the front shock absorber with coil spring.

   Torque: 210 N*m (2,140 kgf*cm, 155 ft.*lbf) 

   NOTE: When installing the bolt, hold the nut not to rotate.
   Fig 2: Installing Bolts And Nuts To Lower Side Of Front Shock Absorber With Coil Spring

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Fully tighten the lock nut.

   Torque: 49 N*m (500 kgf cm, 36 ft.*lbf) 

   Fig 3: Locating Lock Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Install the front flexible hose No.1 and speed sensor front LH with the bolt.

   Torque: 19 N*m (189 kgf*cm, 14 ft.*lbf) 

   Fig 4: Locating Front Flexible Hose And Speed Sensor Front LH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the front stabilizer link assembly LH with the nut.

   Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf) 

   HINT:

   If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.

   Fig 5: Installing Front Stabilizer Link Assembly LH With Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the cowl top brace and cowl top panel sub-assembly outer front with the 9 bolts.

   Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

2. Connect the wire harness to the cowl top panel sub-assembly outer front.
Fig 6: Locating Cowl Top Brace And Cowl Top Panel Subassembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

(See COMPONENTS )

HINT:

(See COMPONENTS )

HINT:

(See COMPONENTS )

Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

HINT:

(See ADJUSTMENT  )