Engine Coolant Temperature Sensor: Installation

INSTALL E.F.I. ENGINE COOLANT TEMPERATURE SENSOR
1. Using a 19 mm deep socket wrench, install the water temperature sensor with a new gasket.
  Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
2. Connect the connector.
  
  Fig 1: Installing Water Temperature Sensor With Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FUEL PIPE SUB-ASSEMBLY NO.2 (See INSTALLATION )
INSTALL INTAKE AIR SURGE TANK (See INSTALLATION )
INSTALL AIR CLEANER ASSEMBLY
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
ADD ENGINE COOLANT (See REPLACEMENT )
CHECK FOR FUEL LEAKAGE
CHECK FOR ENGINE COOLANT LEAKAGE (See REPLACEMENT )
INSTALL V-BANK COVER (See INSPECTION )