Engine Coolant Temperature Sensor: Installation

INSTALL ENGINE COOLANT TEMPERATURE SENSOR
1. Install a new gasket to the sensor.
2. Install the sensor.
  Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
3. Connect the sensor connector.
  
  Fig 1: Identifying Engine Coolant Temperature Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INTAKE MANIFOLD
1. Set a new gasket on each cylinder head.
  NOTE:
  - Align the port holes of the gasket and cylinder head.
  - Be careful of the installation direction.
  Fig 2: Installing Gasket On Cylinder Head
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Set the intake manifold on the cylinder heads.
3. Install and uniformly tighten the 10 bolts in several passes.
  Torque: 26 N*m (265 kgf*cm, 19 ft.*lbf)
  
  Fig 3: Locating Intake Manifold Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the 6 fuel injector connectors.
INSTALL INTAKE AIR SURGE TANK
1. Install the intake air surge tank (See INSTALLATION ).
CONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY (See INSTALLATION )
CONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY (See INSTALLATION )
ADD ENGINE COOLANT (See REPLACEMENT )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
INSPECT FOR ENGINE COOLANT LEAK (See ON-VEHICLE INSPECTION )