LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> Corolla LE, Standard >> Repair and Diagnosis (Single Page) >> Steering >> Steering Column >> Steering Column >> Steering Column Assembly >> Reassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Column Assembly: Reassembly

  1. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY 
    1. Install the ignition or starter switch assembly to the steering column upper bracket assembly with the 2 screws.
  2. INSTALL UN-LOCK WARNING SWITCH ASSEMBLY 
    1. Install the un-lock warning switch assembly.
    2. Connect the un-lock warning switch assembly connector to the ignition or starter switch assembly.
      Fig 1: Locating Un-Lock Warning Switch Assembly
      G05195173Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY 
    1. Make sure that the ignition switch lock cylinder assembly is at the ACC position.
    2. Install the ignition switch lock cylinder assembly.
  4. INSTALL TRANSPONDER KEY AMPLIFIER 
    1. Align the transponder key amplifier with the installation position of the upper bracket with the amplifier inclined.
    2. Push the transponder key amplifier up and install it to the upper bracket.
    NOTE: Take care not to push the amplifier up with excessive force to prevent it from being damaged.
    Fig 2: Locating Transponder Key Amplifier
    G05195175Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL STEERING COLUMN UPPER BRACKET ASSEMBLY 
    1. Temporarily install the steering column upper with switch bracket assembly and steering column upper clamp with 2 new tapered-head bolts.
    2. Tighten the 2 tapered-head bolts until the bolt heads break off.
    Fig 3: Identifying Steering Column Upper Bracket Bolts
    G05195176Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals