Inspection Procedure
WARNING: This page is about a different car, the 2008 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
- Measure the voltage according to the value(s) in the table below.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Standard voltage
VOLTAGE CHARTTester connection Condition Specified condition B9-5 - Body ground Engine running 10 to 14 V
NG: Go to step 2
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
- Measure the voltage according to the value(s) in the table below.
- INSPECT GENERATOR ASSEMBLY
- Inspect generator assembly (See INSPECTION for 2AZ-FE, See REMOVAL for 3MZ-FE).
NG: CHECK AND REPLACE GENERATOR ASSEMBLY
OK: REPAIR OR REPLACE HARNESS OR CONNECTOR (GENERATOR ASSEMBLY - MULTIPLEX NETWORK BODY ECU)