Inspection Procedure

1. Disconnect navigation receiver assembly connector E6 and television display assembly connector Q13.
   Fig 1: Identifying E6 Navigation Receiver Assembly Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   RESISTANCE REFERENCE TABLE
   
   

   Tester Connection	Condition	Specified Condition
   E6-1 (W+) - Q13-11 (NTS1)	Always	Below 1 Ω
   E6-4 (W-) - Q13-10 (SG3)	Always	Below 1 Ω
   E6-1 (W+) - Body ground	Always	10 kΩ or higher
   E6-4 (W-) - Body ground	Always	10 kΩ or higher

   Fig 2: Identifying Q13 Television Display Assembly Connector Terminals (1 Of 2)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Reconnect television display assembly connector Q13.
2. Measure the waveform according to the table below.

   OK 

   WAVEFORM REFERENCE TABLE
   
   

   Tester Connection	Condition	Specified Condition
   Q13-11 (NTS1) - Body ground	DVD display is ON	A waveform synchronized with display signals is output

   HINT:

   The waveform pattern may differ from that shown below due to differences in the oscilloscope setting. A normal television display assembly operating condition can be determined if any waveform is output.

   Fig 3: Identifying Q13 Television Display Assembly Connector Terminals (2 Of 2)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Oscilloscope waveform
   1. Terminal: Q13-11 (NTS1) - Body ground

      Setting: 200 mV/DIV., 10 μs/DIV.

      Condition: DVD display is ON.

   Fig 4: Identifying Oscilloscope Waveform

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE TELEVISION DISPLAY ASSEMBLY  (See REMOVAL )

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )