LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> Highlander Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Service Specifications - Hybrid) >> Brake Control System >> Service Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Service Data

WARNING: This page is about a different variant/trim than selected.
SERVICE DATA SPECIFICATION (BRAKE CONTROL)

Brake actuator assembly operation FR system solenoids Sensor 10 to 20 sec. after check start (V) 35 sec. or more after check start (V)
Master Cylinder Sensor 0.3 to 0.7 0.3 to 0.7
Master Cylinder Sensor 2 0.3 to 0.7 0.3 to 0.7
FR W/C Sensor 2.5 to 4.5 0.3 to 0.7
FL W/C Sensor 0.3 to 0.7 0.3 to 0.7
RR W/C Sensor 0.3 to 0.7 0.3 to 0.7
RL W/C Sensor 0.3 to 0.7 0.3 to 0.7
FL system solenoids Sensor 10 to 20 sec. after check start (V) 35 sec. or more after check start (V)
Master Cylinder Sensor 0.3 to 0.7 0.3 to 0.7
Master Cylinder Sensor 2 0.3 to 0.7 0.3 to 0.7
FR W/C Sensor 0.3 to 0.7 0.3 to 0.7
FL W/C Sensor 2.5 to 4.5 0.3 to 0.7
RR W/C Sensor 0.3 to 0.7 0.3 to 0.7
RL W/C, Sensor 0.3 to 0.7 0.3 to 0.7
RR system solenoids Sensor 10 to 20 sec. after check start (V) 35 sec. or more after check start (V)
Master Cylinder Sensor 0.3 to 0.7 0.3 to 0.7
Master Cylinder Sensor 2 0.3 to 0.7 0.3 to 0.7
FR W/C Sensor 0.3 to 0.7 0.3 to 0.7
FL W/C Sensor 0.3 to 0.7 0.3 to 0.7
RR W/C Sensor 2.5 to 4.7 0.3 to 0.7
RL W/C Sensor 0.3 to 0.7 0.3 to 0.7
RL system solenoids Sensor 10 to 20 sec. after check start (V) 35 sec. or more after check start (V)
Master Cylinder Sensor 0.3 to 0.7 0.3 to 0.7
Master Cylinder Sensor 2 0.3 to 0.7 0.3 to 0.7
FR W/C Sensor 0.3 to 0.7 0.3 to 0.7
FL W/C Sensor 0.3 to 0.7 0.3 to 0.7
RR W/C Sensor 0.3 to 0.7 0.3 to 0.7
RL W/C Sensor 2.5 to 4.7 0.3 to 0.7
SERVICE DATA SPECIFICATION (BRAKE CONTROL)

PRESSURE SENSOR OPERATION Brake effort {N (kgf, lbf)} Master Cylinder Sensor (V) Master Cylinder Sensor 2 (V)
200 (20.4, 45) 0.90 to 1.30 0.90 to 1.30
500(51, 112) 2.10 to 2.50 2.10 to 2.50
Front right side Brake effort {N (kgf, lbf)} Front right wheel hydraulic pressure {MPa (kgf/cm2 , psi)} FR W/C Sensor (V)
50 (5.1, 11) 2.4 (24.5, 348) 0.80 to 1.20
100 (10.2, 22) 5.4(54.1,783) 1.40 to 1.80
150 (15.3, 34) 6.5 (66.3, 943) 1.60 to 2.00
200 (20.4, 45) 7.1 (72.4, 1030) 1.75 to 2.15
Front left side Brake effort {N (kgf, lbf)} Front left wheel hydraulic pressure {MPa (kgf/cm2 , psi)} FL W/C Sensor (V)
50 (5.1, 11) 2.4 (24.5, 348) 0.80 to 1.20
100 (10.2, 22) 5.4 (54.1,783) 1.40 to 1.80
150 (15.3,34) 6.5 (66.3, 943) 1.60 to 2.00
200 (20.4, 45) 7.1 (72.4, 1030) 1.75 to 2.15
Rear right side Brake effort {N (kgf, lbf)} Rear right wheel hydraulic pressure {MPa (kgf/cm2 , psi)} RR W/C Sensor (V)
50 (5.1,11) 2.4 (24.5, 348) 0.80 to 1.20
100 (10.2, 22) 5.0 (51.0,725) 1.30 to 1.70
150 (15.3, 34) 5.0 (51.0,725) 1.30 to 1.70
200 (20.4, 45) 5.0 (51.0,725) 1.30 to 1.70
Rear left side Brake effort {N (kgf, lbf)} Rear left wheel hydraulic pressure {MPa (kgf/cm2 , psi)} RL W/C Sensor (V)
50 (5.1,11) 2.4 (24.5, 348) 0.80 to 1.20
100 (10.2,22) 5.0 (51.0,725) 1.30 to 1.70
150 (15.3,34) 5.0 (51.0,725) 1.30 to 1.70
200 (20.4, 45) 5.0 (51.0,725) 1.30 to 1.70
RESISTANCE SPECIFICATION

  Tester Connection Condition Specified Condition
Stop Light Control relay 3-4 Voltage is not applied between terminals 1 and 2 Below 1 Ω
3-5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
3-4 Voltage is applied between terminals 1 and 2 10 kΩ or higher
3-5 Voltage is applied between terminals 1 and 2 Below 1Ω
ABS MAIN relay Resistance 3-5 Always 10 kΩ or higher
Resistance 3-5 Battery positive voltage is applied between terminals 1 and 2 Below 1 Ω
ABS MOTOR relay Resistance 3 - 5 Always 10 kΩ or higher
Resistance 3-5 Battery positive voltage is applied between terminals 1 and 2 Below 1 Ω
Brake Pedal Stroke Sensor   When brake pedal is released 0.7 to 1.3 V
scientia non olet · About LEMON Manuals