LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> Highlander Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System (Hybrid)) >> Crankshaft Position Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
    2. Install the crankshaft position sensor with the bolt.

      Torque: 8.0 N*m (80 kgf*cm, 71 in.*lbf) 

    3. Connect the crankshaft position sensor connector.
      4. Fig 1: Locating Crankshaft Position Sensor With Bolt
      G05245825Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT FENDER APRON SEAL RH 
  3. INSTALL FRONT FENDER LINER RH 
  4. INSTALL NO. 1 ENGINE UNDER COVER  (See INSTALLATION )
scientia non olet · About LEMON Manuals