LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> Land Cruiser >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - System & Component Testing, On-Vehicle Inspection, Removal & Installation >> Accelerator Pedal >> On-Vehicle Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

On-Vehicle Inspection

  1. INSPECT ACCELERATOR PEDAL ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream main switch on.
    4. Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accelerator Position No. 1 and Accelerator Position No. 2.
    5. Read the value displayed on the Techstream.

      Standard Voltage 

      STANDARD VOLTAGE SPECIFICATION

      Accelerator Pedal Operations Accelerator Position No. 1 Accelerator Position No. 2
      Released 0.5 to 1.1V 1.2 to 2.0 V
      Depressed 2.6 to 4.5 V 3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal, wire harness and ECM.

scientia non olet · About LEMON Manuals