Transmission Control Cable Assembly: Installation

1. Install the retainer to the shift cable.
2. Pull in the control cable assembly to the body.
3. Install the 2 bolts.

   Torque: 5.0 N*m (50 kgf*cm, 44 in.*lbf) 

   Fig 1: Identifying Transmission Control Cable Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the control cable to the shift lever plate.
   Fig 2: Identifying Shift Lever Plate

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the control cable end to the floor shift assembly.

   HINT:

   Install it with the uneven surface facing up.

   Fig 3: Identifying Control Cable End

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Install the control cable with the 2 nuts to the body.

   Torque: 5.0 N*m (50 kgf*cm, 44 in.*lbf) 

   Fig 4: Identifying Control Cable Nuts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Connect the control cable to the control cable support.
Fig 5: Identifying Control Cable Support
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Temporarily install the control cable to the control shaft lever with nut.
9. Install the control cable with the clip to the bracket.
   NOTE: Insert the cable securely.

Fig 6: Identifying Transmission Control Cable Assembly

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf) 

1. Install the heat insulator with the 3 nuts.

   Torque: 5.0 N*m (50 kgf*cm, 44 in.*lbf) 

HINT:

See INSTALLATION

1. Install the floor panel brace with the 2 nuts.

   Torque: 30 N*m (302 kgf*cm, 22 ft.*lbf) 

1. Connect the oxygen sensor connector.
2. Install the floor carpet and foot rest.

HINT:

See CHECK MODE PROCEDURE