LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> Matrix Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Control System (Service Information)) >> Knock Sensor >> Removal (From 12/2010) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal (From 12/2010): Removal

WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. PREVENT GASOLINE FROM SPILLING OUT 
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  3. DRAIN ENGINE COOLANT  . Refer to REPLACEMENT - Step 1
  4. REMOVE WINDSHIELD WIPER MOTOR & LINK ASSEMBLY 

    Refer to REMOVAL

  5. REMOVE COWL TOP PANEL OUTER  . Refer to REMOVAL - Step 5
  6. REMOVE V-BANK COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 9
  7. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE  . Refer to REMOVAL - Step 10
  8. REMOVE INTAKE AIR SURGE TANK  . Refer to REMOVAL - Step 11
  9. REMOVE INTAKE MANIFOLD  . Refer to REMOVAL - Step 75
  10. REMOVE KNOCK CONTROL SENSOR 
    1. Disconnect the 2 knock control sensor connectors.
      Fig 1: Locating Knock Control Sensor Connectors And Bolts
      GTY288033Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and 2 knock control sensors.
scientia non olet · About LEMON Manuals