Steering Pad Switch: Inspection: Inspection
WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT STEERING PAD SWITCH ASSEMBLY
- Disconnect the steering pad switch assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition d1-10 (AU1) - d1-8 (EAU) No switch pushed 95 to 105 kΩ d1-10 (AU1) - d1-8 (EAU) Seek+ switch pushed Below 2.5 Ω d1-10 (AU1) - d1-8 (EAU) Seek- switch pushed 312 to 345 Ω d1-10 (AU1) - d1-8 (EAU) Volume+ switch pushed 950 to 1050 Ω d1-10 (AU1) - d1-8 (EAU) Volume- switch pushed 2954 to 3265 Ω d1-9 (AU2) - d1-8 (EAU) No switch pushed 95 to 105 kΩ d1-9 (AU2) - d1-8 (EAU) MODE switch pushed Below 2.5 Ω d1-9 (AU2) - d1-8 (EAU) Voice switch pushed 2954 to 3265 Ω d1-9 (AU2) - d1-8 (EAU) On hook switch pushed 312 to 345 Ω d1-9 (AU2) - d1-8 (EAU) Off hook switch pushed 950 to 1050 Ω TEXT IN ILLUSTRATION*a Component without harness connected
(Steering Pad Switch Assembly)*b Volume+ *c Volume- *d Seek- *e MODE *f Seek+ *g On hook *h Off hook *i Voice - -