Inspection Procedure

Fig 1: Inspecting Radio Receiver

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the radio receiver connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Condition	Specified Condition
   TX+ - TX-	Always	60 to 80 Ω

NG: REPLACE RADIO RECEIVER 

OK : Go to next step. 

HINT:

For details of the connectors, refer to the "TERMINALS OF ECU " .

1. Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.
   1. Disconnect all connectors in all AVC-LAN circuits.
   2. Check for an open or short in all AVC-LAN circuits.

      OK: There is no open or short circuit. 

      Fig 2: AVC-LAN - Wiring Diagram

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE