Front Speed Sensor: Removal

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE FRONT WHEEL 
3. REMOVE FRONT FENDER LINER LH 
4. REMOVE FRONT SPEED SENSOR LH 
   1. Disconnect the sensor connector.
      Fig 1: Locating Sensor Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Remove the sensor clip (labeled A), bolt (labeled B) and sensor clamp (labeled C).
   Fig 2: Locating Sensor Clip (Labeled A), Bolt (Labeled B) And Sensor Clamp (Labeled C)
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Remove the sensor clip (labeled D), bolt (labeled E) and sensor clamp (labeled F).
      Fig 3: Locating Sensor Clip (Labeled D), Bolt (Labeled E) And Sensor Clamp (Labeled F)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Remove the bolt and sensor body from the knuckle.
      NOTE: Keep the sensor tip and sensor installation hole free from foreign matter.
      Fig 4: Locating Bolt And Sensor Body From Knuckle

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002