Inspection Procedure
NOTE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (see CALIBRATION
).
- CHECK CAN COMMUNICATION SYSTEM
- Check if the CAN communication DTC is output (see DIAGNOSIS SYSTEM
).
Result
DTC RESULT DESCRIPTIONResult Proceed to DTC is not output A DTC is output B
B: REPAIR CAN COMMUNICATION SYSTEM
A: Go to next step.
- Check if the CAN communication DTC is output (see DIAGNOSIS SYSTEM
).
- PERFORM ACTIVE TEST BY TECHSTREAM (SKID CONTROL BUZZER)
- Select the Active Test, generate a control command, and then check that the skid control buzzer operate.
ABS/VSC/TRAC:
CONTROL RANGE AND DIAGNOSTIC NOTETester Display Test Part Control Range Diagnostic Note Buzzer Skid control buzzer Buzzer ON / OFF Buzzer can be heard OK: The skid control buzzer can be heard.
OK: REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY
NG: Go to next step.
- Select the Active Test, generate a control command, and then check that the skid control buzzer operate.
- INSPECT COMBINATION METER
- Inspect the combination meter (see HOW TO PROCEED WITH TROUBLESHOOTING ).
NG: REPLACE COMBINATION METER
OK: REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY