Camshaft Position Sensor: Installation
- INSTALL CAMSHAFT POSITION SENSOR NOTE: Make sure that the O-ring is not cracked or jammed when installing it.
- Apply Ω light coat of engine oil to the O-ring of the sensor.
- Install the sensor with the bolt.
Torque: 9.0 N*m (90 kgf*cm, 80 in.*lbf)
- Connect the sensor connector.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- INSTALL AIR CLEANER CAP (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- CHECK FOR ENGINE OIL LEAKAGE
- INSTALL NO. 1 ENGINE COVER (See INSTALLATION )