LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> RAV4 Base, 3.5 K, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control System (2GR-FE) >> Knock Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Knock Sensor: Installation

  1. INSTALL KNOCK SENSOR 
    1. Install the 2 sensors with the 2 bolts as shown in the illustration.

      Torque: 20 N*m (205 kgf*cm, 15 ft.*lbf) 

      NOTE: Make sure that the knock sensor is in the correct position.
      Fig 1: Identifying Knock Sensor
      G05184286Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the 2 sensor connectors.
  2. INSTALL INTAKE MANIFOLD  (See INSTALLATION )
  3. INSTALL INTAKE AIR SURGE TANK ASSEMBLY  (See INSTALLATION )
  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  5. CHECK FOR ENGINE COOLANT LEAKS  (See ON-VEHICLE INSPECTION )
  6. CHECK FOR FUEL LEAKS 
  7. CHECK FOR ENGINE OIL LEAKS  (See REPLACEMENT )
scientia non olet · About LEMON Manuals