LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> Sequoia Platinum, RWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control/Dynamic Control Systems >> Steering Angle Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Angle Sensor: Installation

  1. INSTALL STEERING ANGLE SENSOR 
    1. Align the pins on the spiral cable with the installation holes on the steering sensor.
    2. Attach the 6 claws and install the spiral cable to the steering sensor.
      Fig 1: Aligning Pins On Spiral Cable
      G04951179Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY  (See INSTALLATION )
  3. INSTALL UPPER STEERING COLUMN COVER  (See INSTALLATION )
  4. INSTALL LOWER STEERING COLUMN COVER  (See INSTALLATION )
  5. ADJUST SPIRAL CABLE  (See INSTALLATION )
  6. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  7. INSTALL STEERING PAD  (See INSTALLATION )
  8. INSTALL LOWER NO. 3 STEERING WHEEL COVER  (See INSTALLATION )
  9. INSTALL LOWER NO. 2 STEERING WHEEL COVER  (See INSTALLATION )
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  11. INSPECT SRS WARNING LIGHT  (See DIAGNOSIS SYSTEM )
scientia non olet · About LEMON Manuals