LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> Yaris Base, 2D Hatchback, Standard >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Brake Control System >> Skid Control Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Skid Control Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE REAR WHEEL 
  3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY  (See REMOVAL )
  4. DISCONNECT SKID CONTROL SENSOR WIRE  (See REMOVAL )
  5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY  (See REMOVAL )
  6. REMOVE SKID CONTROL SENSOR 
    1. Install the 4 hub nuts and the 4 hub bolts onto the rear axle hub, and then fix the rear axle hub in a vice between aluminum plates.
      NOTE: If the skid control sensor is dropped or heavily damaged, replace the rear axle hub and bearing.
    2. Using a 3 mm pin punch and hammer, remove the 2 pins from SST (09520-00031) and remove the attachment (09521-00010).
    3. Using SST and the 2 bolts (90101-12007), remove the skid control sensor from the rear axle hub.

      SST 09520-00031 (09520-00040), 09521-00020, 09950-00020 

      NOTE:
      • Pull the skid control sensor off straight, being careful not to make contact with the skid control sensor rotor.
      • If the skid control sensor rotor is damaged or deformed, replace the rear axle hub and bearing.
      • Do not damage the skid control sensor or rear axle hub contact surfaces.
      • Keep the sensor rotor free of foreign matter.
        Fig 1: Identifying Skid Control Sensor
        G04832247Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals