Input Signals
- Engine coolant temp. signal circuit
The engine coolant temp. sensor detects the engine coolant temperature and has a built-in thermistor whose resistance varies according to the engine coolant temperature is input into TERMINAL THW of the engine control module as a control signal.
- Intake air temp. signal circuit
The intake air temp. sensor is installed in the mass air flow meter and detects the intake air temperature, which is input as a control signal into TERMINAL THA of the engine control module.
- Oxygen sensor signal circuit
The oxygen density in the exhaust gases is detected and input as a control signal into TERMINALS OX1B and OX2B of the engine control module.
- RPM signal circuit
The engine RPM is detected by the crankshaft position sensor which is installed in the cylinder block and the signal is input into TERMINAL NE+ of the engine control module as a control signal.
- Throttle position sensor signal circuit
The throttle position sensor detects the throttle valve opening angle as a control signal, which is input into TERMINALS VTA1 and VTA2 of the engine control module.
- Vehicle speed circuit
The vehicle speed sensor detects the vehicle speed, and the signal is input into TERMINAL SPD of the engine control module via the combination meter, from TERMINAL SP1 of the skid control ECU with actuator.
- Battery signal circuit
Voltage is constantly applied to TERMINAL BATT of the engine control module. When the power SW is pushed on (Power SW type), or when the ignition SW is turned on (Ignition SW type), the voltage for engine control module start-up power supply is applied to TERMINAL +B and +B2 of engine control module via EFI relay.
- Intake air volume signal circuit
The intake air volume is detected by the mass air flow meter, and is input as a control signal to TERMINAL VG of the engine control module.
- Stop lamp SW signal circuit
The stop lamp SW is used to detect whether the vehicle is braking or not, and the signal is input into TERMINAL STP of the engine control module as a control signal.
- Starter signal circuit
To confirm whether the engine is cranking, the voltage which is being applied to the starter motor during cranking is detected and the signal is input into TERMINAL STA of the engine control module as a control signal.
- Engine knock signal circuit
Engine knocking is detected by knock sensors (Bank 1) and (Bank 2), then the signals are input into TERMINALS KNK1 and KNK2 of the engine control module as control signals.
- Air fuel ratio signal circuit
The air fuel ratio is detected and input as a control signal into TERMINALS A1A+ and A2A+ of the engine control module.