Inspection Procedure

1. Remove the switch.
2. Measure the resistance of the switch when the switch is operated.

   Resistance 

   RESISTANCE SPECIFICATION
   
   

   Switch Condition	Tester Connection	Specified Condition
   UP	1 (D) - 2 (SD) 3 (U) - 4 (B)	Below 1 Ω
   OFF	1 (D) - 2 (SD) 3 (U) - 5 (SU)	Below 1 Ω
   AUTO DOWN	1 (D) - 4 (B) 3 (U) - 5 (SU)	Below 1 Ω

   Fig 1: Identifying I2 Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY (REAR RH) 

OK : PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE