Front Speed Sensor: Installation

WARNING: This page is about a different car, the 2008 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT SPEED SENSOR
1. Install the speed sensor front LH with the bolt.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  NOTE: Prevent foreign matter from attaching to the sensor tip.
  
  Fig 1: Locating Front Speed Sensor Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the sensor harness brackets with the 2 bolts to the body and shock absorber assembly.
  Torque: Bolt A
  
  5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Bolt B
  
  19 N*m (192 kgf*cm, 14 ft.*lbf)
3. Connect the clamp to the steering knuckle.
  NOTE: Do not twist the wire harness for speed sensor front LH when installing the speed sensor.
  
  Fig 2: Locating Sensor Harness Brackets With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the speed sensor connector and clamp.
INSTALL FRONT FENDER LINER LH
INSTALL FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
CHECK ABS SPEED SENSOR SIGNAL
1. Check the ABS speed sensor signal (See TEST MODE PROCEDURE without VSC, or TEST MODE PROCEDURE with VSC).
  
  Fig 3: Locating Speed Sensor Connector And Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002