Inspection Procedure

1. Disconnect the navigation receiver assembly connector F9.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester connection	Condition	Specified condition
   GND - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard voltage 

   VOLTAGE SPECIFICATION
   
   

   Tester connection	Condition	Specified condition
   B - GND	Always	10 to 14 V
   ACC - GND	Ignition SW on (ACC)	10 to 14 V

   Fig 1: Identifying Navigation Receiver Assembly Connector F9

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE