LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Camry Base, Standard >> Repair and Diagnosis (Single Page) >> Body & Frame >> Windows >> Windshield/Window Glass (Except Hybrid) >> Power Window Control System >> Front Passenger Side Power Window Switch Power Source Circuit >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

  1. CHECK WIRE HARNESS (POWER WINDOW REGULATOR SWITCH - BATTERY AND BODY GROUND) 
    1. Disconnect the H6 connector.
      Fig 1: Identifying H6 Connector Terminals
      G04981078Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the voltage according to the value(s) in the table below.

    Standard voltage 

    POWER WINDOW REGULATOR SWITCH - BATTERY AND BODY GROUND

    Tester Connection Condition Specified Condition
    3 (B) - Body ground Ignition switch on (IG) 10 to 14 V

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

scientia non olet · About LEMON Manuals