LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Highlander Base, 2.7 A >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System (2GR-FE) - System And Component Testing, Removal, Inspection And Installation) >> Engine Coolant Temperature Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Coolant Temperature Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  2. REMOVE ENGINE UNDER COVER ASSEMBLY  (See REMOVAL )
  3. REMOVE NO. 1 ENGINE UNDER COVER  (See REMOVAL )
  4. DRAIN ENGINE COOLANT  (See COOLANT )
  5. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  6. REMOVE BATTERY  (See REMOVAL )
  7. REMOVE NO. 2 AIR CLEANER INLET  (See REMOVAL )
  8. REMOVE NO. 1 AIR CLEANER INLET  (See REMOVAL )
  9. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE AIR CLEANER CASE SUB-ASSEMBLY  (See REMOVAL )
  11. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the engine coolant temperature sensor connector.
    2. Remove the engine coolant temperature sensor and gasket.
      Fig 1: Locating Engine Coolant Temperature Sensor Connector
      G05414062Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals